We recently restored a pair of old halogen-based head lamps on a Toyota ALTIS. The old head lamp was at that point merely decorative. The new head lamps is a 60W LED projector-based head lamp.

The lamp cover’s condition was beyond polishing. As good as we are at polishing oxidized head lamps, we decided to just swap a new pair of lamp cover since we’re already going to go through the hassle of removing the cover and sealing it back with new butyl.

There were 2 major challenge with this modification – removing the factory butyl and adjusting the new modified LED projector bulbs to the original level.

First challenge: The factory butyl from Toyota was extremely binding and hard, even after so many years. The trick was to set the heat gun to a high enough temperature and proceed to immediately prying the lamp cover from the housing before the factory butyl cools down and sets.

Second challenge: Projector head lamps are great for vision because of its brightness and focus but without careful adjustments and finetuning, it can be dangerously blinding to oncoming traffic. If you drive frequently at night, you would have noticed this hazard on the road.  We’re fortunate that the original high beam bulbs were retained and we could use it as a reference point for the adjustment of the new projector LED bulbs. The use of a laser leveler also helps to ensure the bulbs are properly aligned for the safety of other road users while providing the optimum brightness on the road.